Epson StylusPro 10000 Service Manual page 288

EPSON Stylus Pro 10000/10000CF
o
Is there ink dirt in the sub platen?
o
Is not the dust etc. clogged to the hole of the sub platen (vacuum hole)?
o
Are not the dirt and paper powder adhering to the sub platen?
6. Sensor / Encoder
Confirm whether there is not the adhesion etc. of a piece of paper in the next sensor /
encoder department. The dirt is removed with the air blower etc. in the case that the dirt was
discovered.
o
CR encoder (Refer to 4.2.3.5)
o
P_Edge sensor (Refer to 4.2.3.6)
o
PF encoder (Refer to 4.2.3.11)
o
Slide home sensor (Refer to 4.2.3.19)
o
CR_HP sensor (Refer to 4.2.3.21)
o
Paper release sensor (Refer to 4.2.3.22)
o
P_FRONT sensor (Refer to 4.2.3.23)
o
P_REAR sensor (Refer to 4.2.3.24)
o
P_THICK sensor (Refer to 4.2.3.27)
o
Shutter home sensor (Refer to 4.2.3.19)
o
Cap sensor (Cap / Pump unit)
o
Pressure sensor / Carriage locking sensor (Ink pump Assy)
7. Cover open detection switch
Confirm whether the next switches are actuated with the open and close of the cover. (It is
not caught, and there is over throw.)
o
Front cover detection switch L/R
Maintenance
o
I/C holder cover switch
8. Suction fan
When the noise of the fan big or the form does not stick to Paper guide L2, remove the dirt
of 3 pieces of suction fan and periphery department in reference to 4.2.3.2.
Maintenance inspection items
Revision A
288