Epson StylusPro 10000 Service Manual page 148

EPSON Stylus Pro 10000/10000CF
9. Remove twelve screws (M4x8) securing the Fan Duct
* Do not mind six screw of the upper sides are dropped inside the fan duct without
taking out.
Screws are covered under sponge of fun duct.
Pay attention so as not to fail the sponge seal with the driver. (When it
fails the air leakage occurs and the adsorption power of the form
becomes low.) Remove the last screw while supporting with the hand,
because the fan duct falls when remove all the screw.
Do the cleaning, because dust etc. is adhering inside, when remove the
fan duct.
Disassembly & assembly
Screw
Screw
Figure 4-74.
10. Open the fan duct as shown below.
Fan Duct
Left
Disassembly Flow
Right
Figure 4-75.
Revision A
148