Printer Setting Menu - Epson Stylus Pro 9000 - Print Engine Service Manual

EPSON Stylus Pro 9000
Table 1-4. SelecType Menus (continued)
Menu
Paper Configuration Register paper thickness and drying time,
and select registered configurations
Cutter Replacement Replace the paper cutter blade
Head Alignment Align the printhead
Printer Basics
Description For more
information
page 16
page 16
page 16

PRINTER SETTING MENU

The bold item is the default setting.
Table 1-5. Printer Setting Menu
Message Item
PLATEN GAP AUTO
THICK
PAGE LINE ON
OFF
INTERFACE AUTO
PARALLEL
MAC
OPTION
PARA. I/F COMPAT*
ECP
CODE PAGE PC437
PC850
ROLL MARG T/B15MM*
15MM
3MM
INIT. PANEL EXEC.
* The printed image is the same size as the printed image using the 0.12 inch (3 mm)
setting. However, the printer adds 0.47 inch (12 mm) of paper clearance (for a total
margin of 0.59 inch [15 mm]) to the top and bottom edges to make paper feeding
more stable and to prevent the paper from rubbing the printheads.
Explanation
Adjusts the platen gap. Normally leave
set to AUTO.
When AUTO CUT OFF is selected on
the control panel, this setting
determines whether a line for manual
cutting is printed
Determines which interface the printer
checks for data. AUTO continuously
checks all interfaces and is good for
normal use. MAC is the serial interface.
Determines the data transfer rate when
using this interface. Normally leave set
to COMPAT*.
Character code setting. PC437 is for
expanded graphics. PC850 is for multi-
lingual.
Top and bottom margins are 0.59 in.
(15 mm). The left and right margins are
0.12 in. (3 mm).
All margins are 0.59 in. (15 mm).
All margins are 0.12 in. (3 mm).
Initialize control panel setup values
14