Viewing The Status Of The Bri Interface - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Configuring Demand Routing for Primary ISDN Modules
Viewing Information about Demand Routing
N o t e
If you do not enter a value for min channels and max channels and you enter
the show isdn-group command, these options are displayed with the value set
to 0. At this value, the options are disabled.

Viewing the Status of the BRI Interface

To view the status of a BRI interface that is associated with the demand
interface, enter:
Syntax: show interface bri <slot>/<port>
Replace <slot> with the slot number in which the backup module is installed,
and replace <port> with the appropriate port number.
For example, to view the status of the BRI 2/1 interface, enter:
ProCurve# show interface bri 2/1
This command reports the status of the BRI interface and the status of the
line. The status of the BRI interface should always be up, indicating that it is
either available to make a connection or it is already maintaining a connection.
If the BRI interface is down, you must bring it up, or it will not be able to place
or receive any calls.
The line status indicates whether or not the BRI interface has established a
connection. If the interface has not established a connection, the line status
should be "ready," as shown in Figure 8-20.
8-65