HP ProCurve 7000dl Series Basic Management And Configuration Manual page 435

N o t e
The do command allows you to enter enable mode commands (such as show
commands) from any context (except the basic mode context).
8. Create the PPP interface.
Syntax: interface ppp <number>
ProCurve(config)# interface ppp 1
9. Configure a static IP address or configure the interface to negotiate the
IP address with the service provider's router.
Syntax: ip address <A.B.C.D> <subnet mask | /prefix length>
or
Syntax: ip address negotiated
For example, to assign the PPP interface a static IP address of 10.1.1.1 /
24, enter:
ProCurve(config-ppp 1)# ip address 10.1.1.1 /24
10. Bind the PPP interface to the ATM subinterface.
Syntax: bind <bind number> atm <number.subinterface number> ppp <number>
pppoe-client
ProCurve(config-ppp 1)# bind 2 atm 1.1 ppp 1 pppoe-client
11. View the status of the PPP interface.
ProCurve(config-ppp 1)# do show interface ppp 1
12. View the running-config to ensure that you have entered two bind com-
mands: one to bind the ADSL interface to the ATM interface and one to
bind the ATM subinterface to the PPP interface. (See Figure 7-27.) Enter:
ProCurve(config-ppp 1)# do show running-config
ADSL WAN Connections
Quick Start
7-61