Status Information - HP ProCurve 7000dl Series Basic Management And Configuration Manual

N o t e
11. Accept the default setting of 64 Kbps for the DS0 speed unless your public
carrier tells you to change this setting. Typically, you will change the
setting only if you are leasing a T1-carrier line and are using the D4 frame
format. In this case, use the pull-down menu to select 56 Kbps.
12. Select the Data Link Layer protocol for this interface—PPP, Frame Relay,
or High-level Data Link Control (HDLC)—and click Apply. The
<Protocol> Configuration Settings window is displayed.
• If your WAN connection is using PPP, see "Configure PPP as the Data
Link Layer Protocol" on page 14-62.
• If your WAN connection is using Frame Relay, see "Configure Frame
Relay as the Data Link Layer Protocol" on page 14-68.
• If your WAN connection is using HDLC, see "Configure HDLC as the
Data Link Layer Protocol" on page 14-74.
If you are using PPP or Frame Relay, you can configure a multilink connection.
For instructions on configuring this multilink, see Chapter 2: Increasing
Bandwidth in the Advanced Management and Configuration Guide.

Status Information

After you configure the Data Link Layer protocol, a new Data Link Layer
section is displayed on the E1 or T1 configuration window. You can now access
the configuration window for the Data Link Layer protocol from the E1 or T1
configuration window.
Status information is displayed at the bottom of the E1 or T1 configuration
window. This readout refreshes automatically every five seconds. To reset the
statistics, click the Clear Statistics button.
Using the Web Browser Interface for Basic Configuration Tasks
Configuring E1 and T1 Interfaces
14-57