Configuring Pppoe Or Pppoa For The Adsl Connection; Status Information - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Status Information

You can view information about both the ATM interface and subinterface. To
view information about the ATM interface, move to the Configuration for
"atm <interface>" window and scroll to the bottom of the window. Likewise,
you can view the status of the ATM subinterface by scrolling to the bottom of
the Configuration for "atm <subinterface>" window.

Configuring PPPoE or PPPoA for the ADSL Connection

After you select PPPoE Client or PPP as the Interface Mode for the ATM
subinterface, a PPP configuration screen is displayed. (See Figure 14-62.) You
must then configure the PPP interface:
1. Enter a description if you need to document information about the PPP
interface. This information will be displayed in the running-config under
the appropriate PPP interface heading.
2. Click the Enabled box to activate the PPP interface.
3. For most environments, you can accept the default setting of 1500 for the
MTU. If you selected the PPPoE Client setting for the ATM Interface Mode,
the ProCurve Secure Router OS will automatically negotiate an MTU of
1492 with the PPP peer. If the two peers fail to negotiate an MTU of 1492,
you may need to set the MTU manually.
4. Select Default Peer Address if you want to configure the IP address of the
PPP peer.
5. If you want to configure PPP authentication, see "PPP Authentication" on
page 14-65.
Using the Web Browser Interface for Basic Configuration Tasks
Configuring ADSL Interfaces
14-85