HP ProCurve 7000dl Series Basic Management And Configuration Manual page 353

Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
-------------------------------------------------------------------
fr 1 is UP
Configuration:
Signaling type is ANSI, signaling role is USER
Multilink disabled
Polling interval is 10 seconds,
full inquiry interval is 6 polling intervals
Link information:
5 minute input rate 24 bits/sec, 0 packets/sec
5 minute output rate 8 bits/sec, 0 packets/sec
BW 1984 Kbit
Queueing method: weighted fair
HDLC tx ring limit: 2
Output queue:0/1/428/64/0 (size/highest/max total/threshold/drops)
Conversations
Available Bandwidth 1488 kilobits/sec
44 packets input, 915 bytes
1 pkts discarded, 0 error pkts, 0 unknown protocol pkts
23 packets output, 322 bytes
1 tx pkts discarded, 0 tx error pkts
Exit - 'Ctrl-C', Freeze - 'f', Resume - 'r'
Figure 6-17. show interface frame-relay <number> realtime
The Secure Router OS will continue to refresh this display with current
information until you enter
To view information about the Frame Relay subinterface, enter the following
command from the enable mode context:
Syntax: show interface frame-relay <number.subinterface number>
Figure 6-18 shows the results of this command for a sample network.
fr 1.1 is Active
Ip address is 10.10.10.1, mask is 255.255.255.252
Interface-dlci is 104
MTU is 1500 bytes, BW is 128000 Kbit (limited)
Average utilization is 92%
Figure 6-18. show interface frame-relay <number.subinterface number>
As Figure 6-18 shows, you can view the status of the Frame Relay subinterface,
the IP address, the DLCI, the MTU size, and the average utilization.
Checking the Status of Logical Interfaces
0/1/256 (active/max active/max total)
to end the display.
Ctrl+C
Status of interface
DLCI
Utilization
6-57