Options For Aaa Authentication: Configuring Banners; Messages, And Prompts - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Controlling Management Access to the ProCurve Secure Router
Using the AAA Subsystem to Control Management Access
2-22
Table 2-3. Default Action if No Named List Is Configured
Access
console access
Telnet access
FTP access
HTTP access
SSH access

Options for AAA Authentication: Configuring Banners,

Messages, and Prompts

To help users log in to the ProCurve Secure Router successfully, you can
customize the following:
banner
message that is displayed when a login attempt fails
password prompt
username prompt
To configure these displays, you use the following command syntax:
Syntax: aaa authentication [banner <banner>| fail-message <message> | password-
prompt <prompt> | username-prompt <prompt>]
Configuring a Banner. A banner is displayed before a user attempts to log
in to the router. By default, the following banner is displayed:
User Access Verification
To configure a banner, move to the global configuration mode context and
enter the aaa authentication banner command followed by any character
that signals the beginning of the banner text. For example, you might enter
the character, as shown below:
@
ProCurve(config)# aaa authentication banner @
You can then type the banner that you want to display. To end the banner, you
must enter the same character that you used to signal the beginning of the
banner. For example, you might enter:
Only authorized users allowed@
Authentication Method
no password required
Telnet password
local user list
local user list
local user list