Settings Explained In Other Chapters - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Settings
access controls to filter incoming and outgoing
traffic
bridging
VPNs
routing commands for OSPF, RIP, or BGP
QoS settings
Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
This description is displayed when you enter the show running-config
command. From the enable mode context, enter:
ProCurve# show running-config
You can also view the description by entering:
ProCurve# show running-config interface fr 1.16
This command displays the running-config settings for only the Frame Relay
1.16 subinterface, as shown below:
interface fr 1.16
frame-relay interface-dlci 16
description WAN link to London office
ip address 192.168.1.1 255.255.255.0
no shutdown

Settings Explained in Other Chapters

In addition to configuring these settings for Frame Relay, you can:
assign ACPs or ACLs to control access to the Frame Relay subinterface
enable bridging
assign crypto maps to enable VPNs
configure settings for routing protocols
configure Quality of Service (QoS) settings
Table 6-8 lists additional configurations that you can enter from the Frame
Relay interface and subinterface and the page number where you can find
information about those configurations.
Table 6-8. Additional Configurations for the Frame Relay
Apply to Frame Relay Interface or
Subinterface
Frame Relay subinterface
Frame Relay subinterface
Frame Relay subinterface
Frame Relay subinterface
Frame Relay interface
Configuring the Logical Interface
Configuration Guide Page
Advanced 5-19, 5-38
Basic 10-6
Advanced 10-46
Advanced 15-1
Advanced 8-28
6-39