Viewing The Configurations That Have Been Entered; Viewing All The Configuration Settings Including Defaults - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Viewing the Configurations That Have Been Entered

To view the settings that have been entered manually and are currently being
used by the ProCurve Secure Router, move to the enable mode context and enter:
ProCurve# show running-config
This command displays the current configurations for the router. You must
browse the output to find the configurations for the Ethernet interfaces, which
are listed under the headings interface eth 0/1 or interface eth 0/2. If you
have configured Ethernet subinterfaces, the configurations for each are listed
under their respective ports.
If you do not want to browse through the entire running-config, you can enter:
ProCurve# show running-config interface eth 0/<port>
This command displays the manually entered configurations for only the
Ethernet interface that you specify.
Likewise, you can view the configuration settings you have entered for the
Ethernet subinterfaces by entering:
Syntax: show running-config interface eth 0/<port number.subinterface number>
Figure 3-7 shows the portion of the show running-config output that is
related to the Ethernet 0/1.1 subinterface.
interface eth 0/1.1
ip address 192.168.1.1
no shutdown
Figure 3-7. Viewing the show running-config Command for an Ethernet
Subinterface

Viewing All the Configuration Settings Including Defaults

The show running-config command displays only the settings that you have
configured for the ProCurve Secure Router. It does not display the default
settings, which are automatically applied to the router. To view all the settings
that are currently applied to the router, enter the following command from the
enable mode context:
ProCurve# show running-config verbose
Viewing the Status of Ethernet Interfaces or Subinterfaces
255.255.255.0
Configuring Ethernet Interfaces
3-23