Configure The Data Link Layer: The Atm Interface And Subinterface; Configure Atm Only - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Table 7-9. Training Modes Supported by the ProCurve Secure Router
Command Option
training-mode ADSL2
training-mode ADSL2+
training-mode G.DMT
training-mode G.LITE
training-mode Multi-Mode
training-mode READSL2
training-mode T1.413
Configure the Data Link Layer: the ATM Interface and
Subinterface
Before you configure the Data Link Layer for the ADSL connection, you must
know the settings that you should enter for the following:
Data Link Layer protocol
• Asynchronous Transfer Mode (ATM) only
• point-to-point protocol (PPP) over Ethernet (PPPoE)
• PPP over ATM (PPPoA)
• routed bridged encapsulation (RBE)
virtual path identifier/virtual channel identifier (VPI/VCI)
ATM encapsulation
IP address
• static IP address
• unnumbered interface
• IP address negotiated with the service provider's router
Your service provider should tell you which settings to enter.

Configure ATM Only

1. From the global configuration mode context, create the ATM interface.
Syntax: interface <interface> <number>
ADSL2+ Annex A ADSL2+ Annex B
Yes Yes
Yes Yes
Yes Yes
Yes No
Yes Yes
Yes No
Yes No
ADSL WAN Connections
Quick Start
7-57