Garmin Cirrus Perspective SR20 Pilot's Manual page 86

FLIGHT INSTRUMENTS
GPS CDI SCALING
When GPS is the selected navigation source, the flight plan legs are sequenced automatically and
annunciations appear on the HSI for the flight phase. Flight phase annunciations are normally shown in
magenta, but when cautionary conditions exist the color changes to yellow. If the current leg in the flight plan
is a heading leg, 'HDG LEG' is annunciated in magenta beneath the aircraft symbol.
The current GPS CDI scale setting is displayed as 'System CDI' on the AUX - System Setup Page and the full-
scale deflection setting may also be changed (2.0 nm, 1.0 nm, 0.3 nm, or Auto) from this page. If the selected
scaling is smaller than the automatic setting for enroute and terminal phases, the CDI is scaled accordingly and
the selected setting is be displayed rather than the flight phase annunciation. Receiver Autonomous Integrity
Monitoring (RAIM) protection limits follow the selected CDI scale and corresponding flight phases.
Changing the selected GPS CDI setting:
1) Use the FMS Knob to select the AUX - System Setup Page on the MFD.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight Selected in the GPS CDI box.
4) Turn the small FMS Knob to highlight the desired setting and press the ENT Key.
5) To cancel the selection, press the FMS Knob or the CLR Key.
When set to 'Auto' (default), the GPS CDI scale automatically adjusts to the desired limits based upon the
current phase of flight (Figure 2-24, Table 2-1).
Cirrus Perspective
72
Figure 2-23 GPS CDI Settings
(AUX - System Setup Page)
by Garmin – Pilot's Guide for the SR20/SR22/SR22T
™
190-00820-08 Rev. A