Garmin Cirrus Perspective SR20 Pilot's Manual page 478

AUTOMATIC FLIGHT CONTROL SYSTEM
DEPARTURE
Climbing to the Selected Altitude and flying an assigned heading:
1) Before takeoff:
a) Use the ALT SEL Knob to set the Selected Altitude to 12,000 feet.
b) Push the GA Switch to activate Takeoff Mode. The flight director Command Bars establish a pitch up attitude to
follow.
c) Press the AP Key to engage the autopilot in a climb, holding the pitch angle commanded in Takeoff Mode and
wings level.
2) In this example, Vertical Speed Mode is used to capture the Selected Altitude (Pitch Hold, Vertical Speed, or
Indicated Airspeed Mode may be used).
a) Press the VS Key to activate Vertical Speed Mode.
The Vertical Speed Reference may be adjusted after Vertical Speed Mode is selected using the NOSE UP/DN
Wheel.
3) Use the HDG Knob to set the Selected Heading, complying with ATC vectors to intercept Airway V4.
Press the HDG Key to activate Heading Select Mode while the autopilot is engaged in the climb. The autopilot
follows the Selected Heading Bug on the HSI and turns the aircraft to the desired heading.
4) As the aircraft nears the Selected Altitude, the flight director transitions to Selected Altitude Capture Mode,
indicated by the green 'ALTS' annunciation flashing for up to 10 seconds.
At 50 feet from the Selected Altitude, the green 'ALT' annunciation flashes for up to 10 seconds; the autopilot
transitions to Altitude Hold Mode and levels the aircraft.
Cirrus Perspective
464
by Garmin – Pilot's Guide for the SR20/SR22/SR22T
™
190-00820-08 Rev. A