Garmin Cirrus Perspective SR20 Pilot's Manual page 629

The Display Database Softkey (Figure B-11) is used to place the cursor in the Database Window. Upon
first press of the Display Database Softkey, the softkey will change to a selected state (black text on gray
background) and the cursor will appear in the Database Window. At this point the user can scroll through
all databases in the Database Window to view status information. If the Display Database Softkey is pressed
repeatedly, the softkey will switch between PFD1 and MFD1. Database status information in the Database
Window will reflect the database of the selected display. After a successful sync and restart, verify that the
proper databases are now in use on the AUX–System Status Page (Figure B-8).
If an error occurs during the synchronization, an error message will be displayed, followed by the affected
display in the Sync Status section of the Database Window (Figure B-9). If a synchronization completes on
one display, but an error occurs on the other, the error message will be displayed with the affected diaplay
listed after it. When an error message (Table B-1) is displayed, the problem must be corrected before the
synchronization can be completed. A power cycle is required to restart synchronization when 'Card Full' or
'Err' is shown.
190-00820-08 Rev. A
Figure B-8 AUX-System Status Page, Database Window
Figure B-9 Synchronization Error Message
Cirrus Perspective by Garmin – Pilot's Guide for the SR20/SR22/SR22T
™
'Card Full' Message
APPENDIX B
Sync Status Section
615