What Does Each Message Mean? - Konica Minolta bizhub 162 Facsimile Manual

When a message appears
6 When a message appears
6.1

What does each message mean?

Message
LINE PROBLEM
(Flashing alternately)
CHECK LINE
*COMM.ERROR*
(####)
*REDIAL ALL FAILED*
*MEM.FULL/TX CANCEL*
*MEM.FULL/RX CANCEL*
HANG UP THE PHONE
TEXT ×1.00
¦[A]§ #XXX: Fax Err
TEXT ×1.00
¦[A]§ #XXX: Comm.Err
*PLEASE WAIT!*
ADMINISTERED BY PC
Fax kit FK-505
Cause
The telephone dialing system
or telephone wiring system
are not set correctly.
The telephone cable is not at-
tached correctly.
Communication is not possi-
ble because of some problem
in the machine.
Communication is not possi-
ble because of a problem with
the recipient/caller's fax ma-
chine.
All redial attempts failed be-
cause either the recipient's
line is busy or there was no
answer.
While sending a fax, the size
of the data for the scanned
image has exceeded the ca-
pacity of the memory.
While receiving a fax, the size
of the data for the scanned
image has exceeded the ca-
pacity of the memory.
The receiver of the connected
telephone is lifted.
1 A fax error occurred while an
operation was being per-
formed in copy mode.
1 A fax transmission error oc-
curred while an operation was
being performed in copy
mode.
This machine is accessing
LSD, RSD or the Admin. Mode
of PageScope Web Connec-
tion.
Remedy
Check the telephone dialing
system or telephone wiring
system and use the appropri-
ate utility mode function to
make the correct settings.
Correctly connect the tele-
phone cable.
Check the transmission re-
sults.
Check the condition of the re-
cipient's line, and then try
sending the fax again.
Retrieve all received faxes
stored in the memory.
Send the fax by direct trans-
mission.
Retrieve all received faxes
stored in the memory.
Replace the receiver of the
connected telephone on the
hook.
Press the [Fax] key to check
the error condition, and take
appropriate measures.
Press the [Fax] key to check
the error condition, and take
appropriate measures.
• Log off from PageScope
Web Connection.
• Exit LSD.
• If no operation is performed
for 600 seconds, the main
screen appears.
6
6-3