System Menu - TallyGenicom 9045N User Manual

2-32 45 PPM Laser Printer User Guide

System Menu

System Menu
The system menu provides access to system settings. Use the following procedure to enter the sys-
tem menu:
1. Press the MENU button on the control panel.
2. Press the NEXT button until the text System Menu is shown on the second line of the dis-
play.
3. Press the SELECT button to enter the system menu.
4. Press the NEXT button to move through the submenus: Factory Defaults, Display Lan-
guage, Power Saver, Wait Timeout, Job Timeout, Jam Recovery, Hex Print, Toner
Low, and Intellifilter.
5. Press the SELECT button to enter a submenu.
Use the procedures in the following table to access and change the system settings:
Submenus
Factory Defaults
When selected, this will reset all
operator settings to the factory
default values. Non US sets
measurements to millimeters. US
sets the measurements to inches.
Display Language
This submenu allows you to change
the language of the display
messages.
Power Saver
This is the number of minutes of idle
time before the printer goes into
power saver mode. In this mode, the
printer will turn off internal motors,
fuser heat, and fan.
Wait Timeout
This submenu allows you to increase
or decrease the length of time (in
seconds) that the printer will remain
in the waiting state—a job is being
processed, no end-of-file has been
detected, and there is no more data
to process. This setting applies to
both PCL and PostScript print jobs.
Default Setting Available Settings
Dependent on U.S.
printer build. Non-U.S.
English English
Francais (French)
Deutsch (German)
Italiano (Italian)
Espanol (Spanish)
15 1 – 60
00020 0 – 99999
Procedure for Changing Setting
1. Press NEXT or PREVIOUS to
toggle between U.S. and NON-U.S.
2. Press SELECT to choose and set
the factory defaults.
1. Press NEXT or PREVIOUS to
scroll through the available
languages: English, French
(Francais), German (Deutsch),
Italian (Italiano), or Spanish
(Espanol).
2. Press SELECT to choose and set
the language.
1. Press NEXT or PREVIOUS to
increase or decrease the digit.
2. Press SELECT to save this setting.
1. Press NEXT or PREVIOUS to
increase or decrease each digit of
the five-digit number.
2. Press SELECT set one digit and
move to the next digit.
3. Press SELECT after changing the
last digit to save this setting.
Jul 07