To setup the printer for the network, see the KX-PNB2 Network Card for
3
Ethernet Quick Installation Guide.
Connecting the power cord and power on
Connect the appropriate end of the power cord supplied to the AC inlet on
1
the rear of the printer.
Connect the other end into a suitable AC outlet.
2
Power the printer on by pressing the power switch.
3
You will hear some movement inside the printer, then "READY" is displayed on the operator
panel display. The printer is ready for printing.
N
OTE
•
When you power on your system for the first time, if "New Hardware Found" is displayed on the
computer screen, close the window, and install the printing software using the procedure
described in "Installing the printer driver" on
Power switch
page
Operator panel display
49.
45
Setting up the Printer