Konica Minolta BIZHUB 750 User Manual page 286

6
Symptom
The edge of the printed
output is dirty.
Even though the paper
misfeed was cleared,
copies cannot be pro-
duced.
Printing with the
"2 1" or "2
1-Side/2-Sides settings
are not possible.
Copying is not possible
even though the pass-
word is entered on a ma-
chine with user
authentication/account
track set.
6-16
Possible cause
Is the ADF platen guide cover
dirty?
Was the selected paper size
larger than the document
(with a Zoom setting of
"×1.000")?
Is the orientation of the docu-
ment different from the orien-
tation of the paper (with a
Zoom setting of "×1.000")?
Was the copy reduced to a
size smaller than the paper
(with a reduced zoom ratio
specified)?
Are there paper misfeeds at
other locations?
Have settings been selected
2" that cannot be combined?
Did the message "Your ac-
count has reached its maxi-
mum allowance." appear?
Troubleshooting
Remedy
Wipe the ADF platen guide cover
with a soft, dry cloth. (See p. 11-5.)
Select a paper size that is the same
size as the document.
Otherwise, select the "Auto Zoom"
setting to enlarge the copy to the
selected paper size. (See p. 4-39.)
Select a paper size that is the same
size as the document. Otherwise,
select a paper orientation that is the
same as that of the document.
Select a zoom ratio that adjusts the
document size to the selected pa-
per size.
Otherwise, select the "Auto Zoom"
setting to reduce the copy to the se-
lected paper size. (See p. 4-39.)
Check the touch panel for JAM lo-
cation display and then remove any
misfeed paper at all other locations.
(See p. 6-7.)
Check the combinations of the se-
lected settings.
Contact your administrator.
bizhub 750/600 (Phase 2)