To Use Finisher Manually - Konica Minolta BIZHUB 750 User Manual

Basic copy operations

To use finisher manually

0 Paper should be placed only in the lower tray of the Post Inserter. Upper
tray cannot be used.
0 Staple (Corner staple / 2 position staples) and Punch can be used in
combination.
0 The size and the number of sheets of the loaded paper differ depending
on the finisher operations to be used. For details, refer to page 4-76.
0 The Punch settings cannot be used with special paper, such as overhead
projector transparencies, label sheets and diazo photosensitive paper. If
a Punch setting is used with special paper, the punch kit may be
damaged.
1
Place a set of paper in the lower tray
of the Post Inserter.
– Staple (Corner staple / 2 position
staples): Place paper face up.
– Punch: Place paper face up.
– Fold&Staple: Place the front of
the finished set up.
– Tri-Fold: Place the outside of the
fold up.
2
Align the guide plate with the paper.
3
Press Staple mode selection button and Punch button to select the
desired mode.
bizhub 750/600 (Phase 2)
Staple mode selection button
Punch button
Lower tray
Start/Stop button
4
4-97