Copying
5.2
Making copies
5.2.1
Making copies using the ADF
1
Switch the machine to copy mode by
pressing the "Copy/Fax/Scan" but-
ton
.
2
Place your document face up on the ADF and adjust document guides
to the document size.
3
As needed, set the copy settings including the document type and
scanning contrast, number of copies, zoom ratio and sort setting. (See
"Basic copy settings" on page 5-6.)
4
To clear the settings, press [Reset].
5
Press [Start] to begin copying.
To stop the copying, press [Stop].
5.2.2
Making copies using the Document glass
1
Switch the machine to copy mode by
pressing the "Copy/Fax/Scan" but-
ton
.
2
Make sure that there is no document on the ADF. If a document is on
the ADF, this document takes priority over the document on the docu-
ment glass.
3
Place your document face down on the document glass and align it to
the left upper corner. Then close the platen cover.
4
Press [Doc. Size] to select the document size, A4, A5 š or F4.
5
As needed, set the copy settings including the document type and
scanning contrast, number of copies, zoom ratio and sort setting. (See
"Basic copy settings" on page 5-6.)
To clear the settings, press [Reset].
6
Press [Start] to begin copying.
To stop the copying, press [Stop].
bizhub 131f/190f
5
5-5