Special Dialing Characters - Konica Minolta BIZHUB 190F User Manual

8
8.1.4

Special dialing characters

Your machine allows you to enter special dialing characters when registering
the auto-dialer. The chart below briefly describes each of these characters.
It also tells you what keys to press on your machine to store those characters
in your autodialer.
Character
/P
–
/N
Note
How to assign the "Pause/Dial Opt." to a soft key, see "Special features
[CD]" on page 12-3.
8-4
What it does
Each pause lasts two seconds.
If you mast wait for another dial tone
or signal at any point in the dialing se-
quence, enter a pause there in the
number.
(You can change the pause lenght.
See "User settings [CD]" on
page 14-3.)
Makes long numbers easier to read.
Enters a "Dial prefix code" to access
to alternative telephone network.
"/N" must be entered to the first of
number.
Autodialer
Keystroke
Press [Advanced Functions] repea-
tedly until "Pause/Dial Opt." appears,
then [Enter]
or
Press a soft key assigned to "Pause/
Dial Opt." once
Press [Advanced Functions] repeat-
edly until "Pause/Dial Opt." appears,
then press [Enter]. Repeat this proce-
dure until a "–" character appears on
the LCD.
or
Press a soft key assigned to "Pause/
DialOpt." twice.
Press [Advanced Functions] repeat-
edly until "Dial Prefix (/N)" appears
and press [Enter].
Repeat this procedure until a "/N"
character appears on the LCD.
or
Press a soft key assigned to "Pause/
Dial Opt." four times.
bizhub 131f/190f