Konica Minolta BIZHUB 190F User Manual page 205

Maintenance and Troubleshooting
Transmission errors
T.1.1
T.1.4
T.2.1
T.2.2
T.2.3
T.3.1
T.4.1
T.4.2
T.4.4
T.5.1,
T.5.2, T.5.3
T.8.1
T.8.10
T.8.11
bizhub 131f/190f
The remote fax machine didn't respond to your machine. Call so-
meone at the remote machine's location.
[Stop] was pressed during transmission.
Either the phone line disconnected during transmission or fax
communication became impossible due to bad phone line condi-
tions. Try the call again.
The two fax machines were incompatible. Your machine sends
and receives only ITU-T Group 3 fax communication, the industry
standard since the early 1980s.
Bad phone line conditions made fax communication impossible.
Conditions can change rapidly, so try the call again later.
The page counter in your fax machine detected a document fee-
der error during transmission. Carefully re-insert the document
into the feeder and re-try the call.
The telephone line disconnected during transmission because of
excessive modem errors or because remote unit ran out of paper.
Try the call again.
After transmission began, poor line conditions developed. Try the
call again.
Poor line conditions prevented transmission. Try the call again.
ECM transmission failed (perhaps due to line noise). Conditions
can change
rapidly, so try the call again later.
A compatibility error occurred.
Line noise or other problems prevented line probing.
The remote fax machine didn't complete the equalizer training
phase.
16
16-27