Removing The Engine Guard; Installing The Engine Guard; Removing The Air Filter - KTM 525 XC ATV 2008 Owner's Manual

MAINTENANCE ON CHASSIS AND ENGINE

Removing the engine guard

Installing the engine guard

x

Removing the air filter

Note
Engine failure Unfiltered intake air has a negative effect on the service life of the engine.
Never ride the vehicle without an air filter since dust and dirt can get into the engine and result in increased wear.
Warning
Environmental hazard Problem materials cause environmental damage.
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Remove screws
600133-10
Check parts for damage and wear. Replace damaged or worn parts.
Position the engine guard on the frame bearer. Mount and tighten screws
and .
Specification
Remaining screws, chassis
Remaining screws, chassis
600133-10
Remove the seat (
Raise the rear of the air filter box lid
press on the carburetor connection boot
the carburetor connection boot from disconnecting from the carburetor.
Unhook the air filter holder
the air filter support.
Remove the air filter from the air filter support.
100077-10
and . Remove the engine guard.
M6
M8
P. 61)
. At the same time, use your other hand to
to kink it at that location. This prevents
and swing it to the side. Remove the air filter
65
10 Nm (7.4 lbf ft)
25 Nm
(18.4 lbf ft)
with