Filling Coolant / Bleeding Cooling System - KTM 525 XC ATV 2008 Owner's Manual

MAINTENANCE ON CHASSIS AND ENGINE

Filling coolant / bleeding cooling system

Warning
Danger of poisoning Coolants are poisonous and a health hazard.
Avoid contact between coolants and skin, eyes and clothing. If fuel gets into your eyes, rinse immediately with water and
contact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor
immediately. Change clothes that have come into contact with coolants. Keep coolants out of the reach of children.
Remove screw
600118-10
Remove screw
600119-10
Remove the radiator cap
600123-11
Open the plug of the compensation tank
Remove the screws
Check parts for damage and wear. Replace damaged or worn parts.
Position the compensating tank
Specification
Remaining screws, chassis
Move the ventilation hose
Mount and tighten the screws
600124-10
Specification
Remaining screws, chassis
x
Position the vehicle as shown and secure it against rolling away. The height differ-
ence must be achieved.
Specification
Height difference
Pull the hand brake lever, push the locking pawl
brake lever. (Figure 100006-10
0 0 A A
The front wheels are blocked.
400360-10
.
.
. Completely drain the coolant.
.
and empty the compensating tank
. Mount and tighten screws
M6
up.
and with new seal rings.
M6
50 cm (19.7 in)
P. 14)
.
.
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
down and release the hand
69