MAINTENANCE ON CHASSIS AND ENGINE
Changing ignition curve
Remove the front trim. (
Changing the ignition curve from Performance to Soft.
Connect the plug-in connector
Soft
The plug-in connector is connected for better driveability. (
Change the ignition curve from Performance to Soft.
Disconnect the plug-in connector
Performance
The plug-in connector is disconnected for better performance. (
Install the front trim. (
Removing the seat
Mounting the seat
Removing the radiator spoiler
Info
The operations are the same on the left and right.
P. 63)
. (Figure 100105-10
. (Figure 100105-10
P. 63)
Pull the release hook
remove from above.
100041-10
Check parts for damage and wear. Replace damaged or worn parts.
Hook the slot
of the seat and slide the tab
100046-10
Push down the rear of the seat until the release hook
Make sure that the seat is correctly locked in.
100043-10
Remove the seat (
Remove the screws
100056-10
P. 60)
P. 60)
P. 60)
P. 60)
back. Lift up the seat at the rear, pull it back and then
on the seat into the collar sleeve
under the fuel tank
P. 61)
on the fuel tank.
61
of the fuel tank, lower the rear
.
engages.