The Restore Configuration Process; Restart; Figure 68 Advanced > System Configuration > Restart; Table 55 Advanced > System Configuration > Firmware - ZyXEL Communications MAX-306 User Manual

11.5.1 The Restore Configuration Process

When the WiMAX Device restores a configuration file, the device automatically
restarts. This causes a temporary network disconnect.
Note: Do not turn off the device while configuration file upload is in progress.
If the WiMAX Device's IP address is different in the configuration file you selected,
you may need to change the IP address of your computer to be in the same
subnet as that of the default management IP address (192.168.5.1). See the
Quick Start Guide or the appendices for details on how to set up your computer's
IP address.
You might have to open a new browser to log in again.
If the upload was not successful, you are notified by Configuration Upload
Error message:
Click Return to go back to the Configuration screen.

11.6 Restart

Click ADVANCED > System Configuration > Restart to reboot the WiMAX
Device without turning the power off.
Note: Restarting the WiMAX Device does not affect its configuration.
Figure 68 ADVANCED > System Configuration > Restart
The following table describes the labels in this screen.
Table 55 ADVANCED > System Configuration > Firmware
LABEL
Restart
User's Guide
DESCRIPTION
Click this button to have the device perform a software restart. The
Power LED blinks as it restarts and the shines steadily if the restart is
successful.
Note: Wait one minute before logging back into the WiMAX Device
after a restart.
Chapter 11 The System Configuration Screens
143