Firmware; Figure 66 Advanced > System Configuration > Firmware - ZyXEL Communications MAX-306 User Manual

Chapter 11 The System Configuration Screens
Table 52 ADVANCED > System Configuration > Dynamic DNS (continued)
LABEL
Enable offline
option
IP Address Update Policy
Use WAN IP
Address
Dynamic DNS
server auto
detect IP
address
Use specified IP
address
Apply
Reset

11.4 Firmware

Click ADVANCED > System Configuration > Firmware to upload new
firmware to the WiMAX Device. Firmware files usually use the system model name
with a "*.bin" extension, such as "WiMAX Device.bin". The upload process uses
HTTP (Hypertext Transfer Protocol) and may take up to two minutes. After a
successful upload, the system will reboot.
Contact your service provider for information on available firmware upgrades.
Note: Only use firmware for your WiMAX Device's specific model.
Figure 66 ADVANCED > System Configuration > Firmware
140
DESCRIPTION
This field is available when CustomDNS is selected in the DDNS Type
field. Select this if your Dynamic DNS service provider redirects traffic
to a URL that you can specify while you are off line. Check with your
Dynamic DNS service provider.
Select this if you want the WiMAX Device to update the domain name
with the WAN port's IP address.
Select this if you want the DDNS server to update the IP address of the
host name(s) automatically. Select this option when there are one or
more NAT routers between the WiMAX Device and the DDNS server.
Note: The DDNS server may not be able to detect the proper IP
address if there is an HTTP proxy server between the
WiMAX Device and the DDNS server.
Select this if you want to use the specified IP address with the host
name(s). Then, specify the IP address. Use this option if you have a
static IP address.
Click to save your changes.
Click to restore your previously saved settings.
User's Guide