9.4.1 Ethernet Pseudowire Setup
Click a pseudowire entry's Edit icon in the ADVANCED > VPN Transport >
Ethernet Pseudowire screen to set up or modify an Ethernet pseudowire's
configuration.
Figure 55 ADVANCED > VPN Transport > Ethernet Pseudowire Setup
The following table describes the labels in this screen.
Table 43 ADVANCED > VPN Transport > Ethernet Pseudowire Setup
LABEL
Active
MPLS VC Label
Ingress
Egress
Pseudowire
Description
Apply
Cancel
User's Guide
DESCRIPTION
Select this to enable the pseudowire. Deselect it to disable the
pseudowire.
Enter the VC ingress label number for this pseudowire. This must
be the egress label number of the peer device. This should not
be the ingress label number of any other Ethernet pseudowire
configured on the WiMAX Device.
Enter the egress label number for this pseudowire. This must be
the ingress label of the peer device. This should not be the
egress label number of any other Ethernet pseudowire
configured on the WiMAX Device.
Enter a brief (up to 31 characters) description for this
pseudowire.
Click to save your changes.
Click to return to the previous screen without saving your
changes.
Chapter 9 The VPN Transport Screens
123