ZyXEL Communications MAX-306 User Manual page 102

Chapter 7 The WAN Configuration Screens
Table 31 ADVANCED > WAN Configuration > Advanced (continued)
LABEL
RIP & Multicast Setup
RIP Direction
RIP Version
Multicast
Windows Networking (NetBIOS over TCP/IP)
Allow between LAN
and WAN
Allow Trigger Dial
Apply
Reset
102
DESCRIPTION
Select the RIP direction from None, Both, In Only and Out Only.
Select the RIP version from RIP-1, RIP-2B and RIP-2M.
IGMP (Internet Group Multicast Protocol) is a network-layer
protocol used to establish membership in a multicast group. The
WiMAX Device supports both IGMP version 1 (IGMP-v1) and
IGMP-v2. Select None to disable it.
Select this check box to forward NetBIOS packets from the LAN to
the WAN and from the WAN to the LAN. If your firewall is enabled
with the default policy set to block WAN to LAN traffic, you also
need to enable the default WAN to LAN firewall rule that forwards
NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the
LAN to the WAN and from the WAN to the LAN.
Select this option to allow NetBIOS packets to initiate calls.
Click to save your changes.
Click to restore your previously saved settings.
User's Guide