Power Button Board
Description
Power button board
The power button board is mounted on the left side of the computer. It is secured with two screws and
has one connector.
To remove the power button board:
1.
Prepare the computer for disassembly (see
on page
2.
Remove the small rear cover (see
3.
Remove the stand (see
4.
Remove the right rear cover (see
5.
Remove the heat sink (see
6.
Remove the rear cover (see
7.
Remove the two screws (1) that secure the board to the computer.
8.
Disconnect the cables from the board (2).
NOTE:
on the wires.
Figure 7-22
9.
Remove the board from the computer.
To install the power button board, reverse the removal procedures.
50
Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
27).
Stand on page
Heat Sink (Thermal Module) on page
Rear Cover on page
Be careful not to damage the cable when disconnecting it from the board. Do not pull
Removing the power button board
Preparing to Disassemble the Computer
Small Rear Cover on page
29).
Right Rear Cover on page
46).
Spare part number
651585-001
28).
35).
38).