Webcam Module - HP Omni Pro 110 Maintenance & Service Manual

Webcam Module

Description
Webcam module
The webcam module is located at the top of the computer. It is located below an upper cover, is
secured with two screws, and has one connector.
To remove the webcam module:
1. Prepare the computer for disassembly (see
on page
2. Position the computer with the top rear facing you.
3. Remove the small rear cover (see
4. Remove the stand (see
5. Remove the right rear cover (see
6. Remove the heat sink (see
7. To remove the upper cover that allows access to the webcam, remove the two screws (1) that
secure the cover to the computer, and then rotate the cover up and off the computer (2).
Figure 7-16
8. Remove the two screws that secure the webcam module to the computer.
Figure 7-17
44 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
27).
Stand on page
Heat Sink (Thermal Module) on page
Removing the upper cover
Removing the webcam module screws
Preparing to Disassemble the Computer
Small Rear Cover on page
29).
Right Rear Cover on page
Spare part number
651586-001
28).
35).
38).