Inverter Board - HP Omni Pro 110 Maintenance & Service Manual

Inverter Board

Description
Inverter board
The inverter board is located on the left side of the computer under the rear cover. It is secured with
two screws and has three connectors.
To remove the inverter board:
1. Prepare the computer for disassembly (see
on page
2. Remove the small rear cover (see
3. Remove the stand (see
4. Remove the right rear cover (see
5. Remove the heat sink (see
6. Remove the rear cover (see
7. Disconnect the three cables from the board (1).
NOTE:
pull on the wires.
48 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
27).
Stand on page
Heat Sink (Thermal Module) on page
Rear Cover on page
Be careful not to damage the cables when disconnecting them from the board. Do not
Preparing to Disassemble the Computer
Small Rear Cover on page
29).
Right Rear Cover on page
46).
Spare part number
651601-001
28).
35).
38).