Rear Cover - HP Omni Pro 110 Maintenance & Service Manual

Rear Cover

The rear cover is secured with five screws. You must pry it off at the seams around the edges of the
computer, starting at the bottom.
To remove the rear coverl:
1. Prepare the computer for disassembly (see
on page
2. Position the computer with the top rear facing you.
3. Remove the small rear cover (see
4. Remove the stand (see
5. Remove the right rear cover (see
6. Remove the heat sink (see
7. Remove the upper cover (if not yet removed) by removing the two screws (1) that secure the
cover to the computer, and then rotating the cover up and off the computer (2).
Figure 7-19
8. Remove the five screws(1) that secure the rear cover to the computer.
46 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
27).
Stand on page
Heat Sink (Thermal Module) on page
Removing the upper cover
Preparing to Disassemble the Computer
Small Rear Cover on page
29).
Right Rear Cover on page
28).
35).
38).