Heat Sink (Thermal Module) - HP Omni Pro 110 Maintenance & Service Manual

Heat Sink (Thermal Module)

Description
Heat sink (thermal module)
The heat sink is secured with five screws and four clips. You have to remove the heat sink cover to
access the heat sink.
To remove the heat sink:
1. Prepare the computer for disassembly (see
on page
2. Position the computer with the rear facing you.
3. Remove the small rear cover (see
4. Remove the stand (see
5. Remove the right rear cover (see
6. Remove the heat sink cover by removing the five screws that secure it to the computer (1), and
then lifting the cover off the computer (2).
Figure 7-11
7. Remove the screw at the top of the heat sink (1).
38 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
27).
Stand on page
Removing the heat sink cover
Preparing to Disassemble the Computer
Small Rear Cover on page
29).
Right Rear Cover on page
Spare part number
651607-001
28).
35).