Front Bezel - HP Omni Pro 110 Maintenance & Service Manual

11. Remove the cables from the clips built into the computer.
12. Remove the drive connector from the computer.
To install the hard drive connector, reverse the removal procedures.

Front Bezel

Description
Front bezel kit
The front bezel is located on the front of the computer and secured with 6 screws and tabs on each
side. You must remove the power button assembly from the bezel to remove the bezel from the
computer.
To remove the front bezel:
1. Prepare the computer for disassembly (see
on page
2. Remove the small rear cover (see
3. Remove the stand (see
4. Remove the right rear cover (see
5. Remove the heat sink (see
6. Remove the rear cover (see
7. Remove the system board shield (see
8. Remove the system board (see
9. Remove the stand bracket (see
60 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
27).
Stand on page
Heat Sink (Thermal Module) on page
Rear Cover on page
Preparing to Disassemble the Computer
Small Rear Cover on page
29).
Right Rear Cover on page
46).
System Board Shield on page
System Board on page
Stand Bracket on page
Spare part number
704214-001
28).
35).
38).
51).
56).
58).