System Board Shield
The system board shield sits above the system board. It is secured with two screws.
To remove the system board shield:
1.
Prepare the computer for disassembly (see
on page
2.
Remove the small rear cover (see
3.
Remove the stand (see
4.
Remove the right rear cover (see
5.
Remove the heat sink (see
6.
Remove the rear cover (see
7.
Remove the two screws (1) that secure the shield to the computer.
8.
Rotate the shield from left to right to remove it from the computer (2).
Figure 7-23
To install the system board shield, reverse the removal procedures.
27).
Stand on page
Heat Sink (Thermal Module) on page
Rear Cover on page
Removing the system board shield
Preparing to Disassemble the Computer
Small Rear Cover on page
29).
Right Rear Cover on page
46).
28).
35).
38).
System Board Shield
51