Drive Connectors - HP Omni Pro 110 Maintenance & Service Manual

Drive Connectors

The drive connectors are located near the middle of the computer, below the fan. They are secured
with two screws and each has two connectors. You must remove the shield to remove the drive
connectors.
This section provides instructions for removing both drive connectors. You can remove either
connector; you do not have to remove both.
To remove the drive connectors:
1. Prepare the computer for disassembly (see
on page
2. Remove the small rear cover (see
3. Remove the stand (see
4. Remove the right rear cover (see
5. Remove the heat sink (see
6. Remove the rear cover (see
7. Remove the stand bracket (see
8. Determine which drive connector you need to remove. The optical drive connector is located
above the hard drive connector.
9. Remove two screws (1) that secure the drive connector to the computer.
10. Disconnect the cables from the system board (2).
NOTE:
on the cables.
Figure 7-29
27).
Stand on page
Heat Sink (Thermal Module) on page
Rear Cover on page
Be careful not to damage the cable when disconnecting it from the board. Do not pull
Removing the drive connectors
Preparing to Disassemble the Computer
Small Rear Cover on page
29).
Right Rear Cover on page
46).
Stand Bracket on page
28).
35).
38).
58).
Drive Connectors 59