Interlogix Concord 4 User Manual page 67

Phone communication test
The purpose of this test is to verify communication between the central
monitoring station and your system.
Most phone tests take only a few minutes, however, your system will try for up to
15 minutes to establish a connection if necessary.
To perform a phone communication test:
1. Disarm the system.
2. Press 8, system or partition master code, 2.
Touchpads display PHONE TEST or SYSTEM ARMED TO PHONE TEST.
If the phone test is successful, systems with the optional voice feature will
announce, "Report okay".
Within a few minutes, the touchpad display should return to the Level 1 display. If
it does not return in 3 minutes, note how long before the Level 1 display returns
and contact the installer.
After the test has started, you can change the arming level to Level 1, then to
Level 2, or Level 3.
Siren test
The purpose of this test is to verify that the panel is activating sirens with the
appropriate warning sounds. You must contact the central monitoring station
before activating any alarms. Otherwise, authorities will be dispatched to the site,
which could result in a fine.
To perform a alarm siren sound test:
1. Contact the central monitoring station to inform them that you will be
activating alarms and they should not dispatch authorities.
2. Activate alarms of each type (fire, police, auxiliary), one at a time.
3. Listen for the appropriate siren sound when each alarm is activated (see
"Alarm sounds and status beeps" on page 83).
4. Contact the central monitoring station to inform them when you are finished
activating alarms.
Concord 4 User Manual 65