Interlogix Concord 4 User Manual page 66

If you need more time to complete testing, restart the timer by pressing 8,
code, 3.
Check to see that all sensors have been tested by pressing *. Touchpads
display a list of untested sensors. You will know that you have finished testing
when touchpads display SENSOR TEST OK or ZONES ALL TESTED.
4. Disarm to Level 1 to exit test mode.
Table 13: Sensor test
Device
Touchpad
Wireless touchpad
Keychain touchpad
Panic button
Door/window sensor
Smoke detector
Motion detector
Rate-of-rise heat
detector
Shock sensor
Phone interface and
voice module
Glass guard sensor
Freeze sensor
64
Test procedure
Trip a police panic alarm, fire alarm,
and auxiliary panic alarm
Press the Bypass key
Press and hold the Lock and Unlock
buttons simultaneously for 3 seconds.
Press and hold the Star and Light
buttons simultaneously for 3 seconds.
Press and hold the appropriate panic
buttons for 3 seconds.
Open the secured door or window
Press and hold the test button until the
system sounds transmission beeps
Avoid the motion detector view for 5
minutes, and then enter its view.
Rub your hands together until warm,
and then place one hand on the
detector for 30 seconds.
Tap the glass twice, away from the
sensor. Wait at least 30 seconds
before testing again.
Activate a police panic by accessing
the system using the phone and
pressing
*, *, *, *, *, *.
Tap the glass 3 or 4 inches from the
sensor.
Apply an ice cube wrapped in plastic
to the sensor. Do not allow the sensor
to get wet.
Touchpad results
POLICE OK, FIRE OK,
AUXILIARY OK, POLICE PANIC
OK, FIRE PANIC OK,
AUXILIARY PANIC OK
ZONES nn OK, TOUCHPAD nn
OK
ZONES nn OK, TOUCHPAD nn
OK
AUXILIARY OK, AUXILIARY
PANIC OK
ZONES nn OK, SENSOR nn OK
ZONES nn OK, SENSOR nn OK
ZONES nn OK, SENSOR nn OK
Zones nn OK, SENSOR nn OK
ZONES nn OK, SENSOR nn OK
Zones nn OK, SENSOR nn OK
POLICE PANIC OK
ZONES nn OK, SENSOR nn OK
ZONES nn OK, SENSOR nn OK
Concord 4 User Manual