No Activity Feature - Interlogix Concord 4 User Manual

Interlogix security systems

Hide thumbs

Table Of Contents

Table of Contents

All user codes and keychain touchpads will send a page if used while this feature

is in effect. Pages indicate:

•

Exception opening report. Reports the arming levels as 111 (Level 1 – Off)

and the user that disarmed the system.

•

Exception closing report. Reports the arming level as 222 (Level 2 – Stay)

or 333 (Level 3 – Away), and the user that armed to that level. See "Pager

notification" on page 30.

The most typical setup of this feature makes use of both exception opening and

closing. (It is possible to use only exception opening or closing, however.)

Scheduled exception opening and closing

You can define opening and closing schedules for exception paging. If you need

assistance setting up a time schedule that fits your needs, see "Time schedules"

on page 31. A touchtone phone can be used to set up this feature, but touchpads

work much better because of their extensive feedback. To attach a schedule to

exception opening or closing:

1. Enter the programming menus by pressing 9, system or partition master

code.

2. Press 0620, #.

3. To schedule exception opening, press # when the touchpad displays

EXCEPTION OPENING or ECEPT OPEN, and then press #.

Or, to schedule exception closing, press B until the touchpad displays

EXCEPTION CLOSING or ECEPT CLOSE, and then press #.

The touchpad displays the first available time schedule

4. Press 2, # to assign the schedule to the event (on), or press 1, # to make the

schedule inactive for the event (off).

5. Press B to go to the next schedule, or press *, 00, # to exit the programming

menus.