Interlogix Concord 4 User Manual page 45

Partition-specific settings
Partition-specific settings affect only one partition. User-programmable, partition-
specific settings include:
• Six partition master codes (one per partition)
• 230 regular user codes (total for all partitions combined)
• 16 time schedules (total for all partitions combined)
• Nine advanced light control set-ups available to each partition
• Latchkey feature
• Notify by exception feature
• Scheduled arming feature
• Speaker volume settings
• Energy saver features and its high and low setpoint
To program any of these features for another partition, you must enter the
programming menus from a touchpad in that partition, or jump into that partition,
then enter the programming menus.
Jumping partitions
If your system uses just one partition, skip this section.
Note:
Typically, you would operate Partition 1 from a touchpad within Partition 1.
However, if you have access to Partition 3 and want to avoid walking a long
distance to a Partition 3 touchpad, you can access Partition 3 from the Partition 1
touchpad by jumping partitions. Depending on how your installer programmed
your system, you may or may not have to enter an access code to jump partition.
The ability to jump to another partition is an attribute you assign to each user
code (see "Assigning code attributes" on page 25). Each code has unique
partition number assignments that it can control. By default, the system master is
the only code that can jump partitions. See "User codes" on page 72 to see if any
other access codes have the ability to jump partitions.
To jump partitions using an access code:
1. From any hardwired touchpad, press 8, code, 6.
Touchpads display ENTER PARTITION or ENTER CMD.
2. Press the desired partition number (1 to 6).
The touchpad sounds one short beep if the jump was successful. One long
beep means the jump was not successful. Alphanumeric touchpads display
the text in the newly entered partition.
3. Proceed to arm, disarm, or program as needed.
The partition assignment reverts if no touchpad buttons are pressed for 10
seconds.
Concord 4 User Manual 43