Ip Ping Test - Procedure 1 - Paradyne iMarc SLV Operation Manual

IP Ping Test – Procedure 1
Procedure
To ping any far-end iMarc unit:
9000-A2-GB33-20
1. Select the IP Ping test.
Main Menu→Test→IP Ping
2. Enter the IP Address of the device the ping is being sent to, then select Start.
NOTE:
If the iMarc unit has just initialized, or the far-end unit has just initialized, it
may take about a minute for the units to learn the routes via the
proprietary RIP.
3. Verify the results of the IP Ping test.
— While the test is running, In Progress... appears in the Status field.
— When the test is finished, Alive should appear as the Status. If any
other message is displayed, additional testing is required.
May 2003
5. Troubleshooting
5-53