Table of Contents
Advertisement
Verifying that Self-Test Passed
To verify that the unit passed its self-test, go to the System and Test Status screen.
Main Menu → Status → System and Test Status
The results of the self-test appear directly under the screen title.
If any failure messages appear, reset the unit by disconnecting, then reconnecting the
power cord. The unit will perform the self-test again. If the failure reappears, call your
service representative for assistance.
Using the Easy Install Feature
An Easy Install screen is provided for custom configurations, but you are not required to
use it for normal installation. You can configure the router by making selections from the
Configuration Edit/Display menu.
Procedure
1. Select the Easy Install feature.
Main Menu → Easy Install
Easy Install Screen Example
main/easy_install
Device Name: Node A
-----------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu
Save
2. Enter the Node IP Address and Subnet Mask.
Node IP Address:
Node Subnet Mask:
TS Access: VPI,VCI
Create a Dedicated Network Management Link
Ethernet Management Options Screen
Network 1 DSL Line Rate Mode
Network 1 DSL Line Rate (Kbps)
Network 1 FRF.8 Encapsulation Mode Transparent
EASY INSTALL
17
6/5/2001 00:01
000.000.000.000
000.000.000.000
0,35
Fixed
784
MainMenu
9788-RtrSLV
Clear
Clear
Exit
Advertisement
Table of Contents
