Limiting Ftp Access - Paradyne iMarc SLV Operation Manual

See Configuring Telnet and/or FTP Session Support in the
Configuration Reference
options.

Limiting FTP Access

FTP access can be limited by:
„
„
„
Procedure
To limit FTP access when the session is not on the TS Access Management Link:
See Configuring Telnet and/or FTP Session Support in the
Configuration Reference
options.
9000-A2-GB33-20
for more information about setting Telnet configuration
Disabling FTP access completely.
Requiring a user ID and password to login.
Limiting FTP bandwidth.
1. Select the Telnet and FTP Session options.
Main Menu→Configuration→Management and Communication→
Telnet and FTP Sessions
2. Set the following configuration options, as appropriate.
To . . .
Disable FTP
Require a login
Limit bandwidth for FTP
3. Save your changes.
for more information about setting FTP configuration
May 2003
iMarc SLV
Set the configuration option . . .
FTP Session to Disable.
Login Required to Enable.
NOTE: User ID and password combinations must
be defined. See Creating a Login
If you want to allow users to configure the unit or
perform file transfers, including downloads, keep
the access at Level-1.
Level-1 access is required to download software to
the unit, or to upload or download configuration
files. Level-3 is sufficient for NMS access for SLV
historical information.
FTP Max Transfer Rate to a rate less than the
network line speed, typically less than or equal to
the CIR.
T
his method is not recommended if SLV reports are
desired since FTP is required to generate the
reports.
iMarc SLV
2. Security and Logins
on page 2-12.
2-7