Verifying That Self-Test Passed; A Quick Guide To Configuration - Paradyne FrameSaver DSL 9783 Installation Manual

Verifying that Self-Test Passed

To verify that the unit passed its self-test, go to the System and Test Status screen.
Main Menu
The results of the self-test appear directly under the screen title.
If any failure messages appear, reset the unit by disconnecting, then reconnecting the
power cord. The unit will perform the self-test again. If the failure reappears, call your
service representative for assistance.

A Quick Guide to Configuration

The FrameSaver unit should operate using the default (factory-set) configuration
options, with exception to the changes specified in these installation instructions. Refer
to the following table for help in navigating through the menus.
Press the . . .
Esc key
Tab key, or
Up ( ), Down ( ),
Left ( ) and Right (
Arrow keys
Enter or Return key
Spacebar
As an example, follow these steps to go to the Configuration Edit/Display menu so you
can start setting up the unit.
Procedure
To load a configuration for editing:
1. From the Main Menu, press the down arrow key twice so the cursor is on
Configuration.
2. Press Enter to display the Configuration menu. The Load Configuration From
menu appears.
3. Press Enter to select Current Configuration (the cursor is already on this
selection). The Configuration Edit/Display menu appears.
This sequence of steps would be shown as the menu selection sequence:
Main Menu
Status System and Test Status
To . . .
Go back one screen or menu level. To see a visual
representation of the menu levels, see Menu Hierarchy in
the Quick Reference.
Move the cursor from one menu item to the next.
)
Complete the menu or option selection.
Display the next available setting when changing a
configuration option. All the available settings for an
option appear at the bottom of the screen.
Configuration
6