Verifying That Self-Test Passed - Paradyne FrameSaver 9783 Installation Instructions Manual

As an example, follow these steps to go to the Configuration Edit/Display menu so you
can start setting up the unit.
"
Procedure
To load a configuration for editing:
1. From the Main Menu, press the Tab key twice or press the down (↓ ) arrow twice
so the cursor is on Configuration.
2. Press Enter to display the Configuration menu. The Load Configuration From
menu appears.
3. Press Enter to select Current Configuration (the cursor is already on this
selection). The Configuration Edit/Display menu appears.
This sequence of steps would be shown as the menu selection sequence:
Main Menu → Configuration
"
Procedure
To save a configuration option change:
1. Press Ctrl-a to switch to the function keys area at the bottom of the screen.
2. Type s (Save) and press Enter. The Save Configuration To menu appears. Press
Enter again to save your changes to the Current Configuration.
3. Press Esc until the Configuration Edit/Display menu reappears to continue
configuring the unit. Press Ctrl-a, type m ( MainMenu), and press Enter to return to
the Main Menu.

Verifying that Self-Test Passed

To verify that the unit passed its self-test, go to the System and Test Status screen.
Main Menu → Status → System and Test Status
The results of the self-test appear directly under the screen title.
If any failure messages appear, reset the unit by disconnecting, then reconnecting the
power cord. The unit will perform the self-test again. If the failure reappears, call your
service representative for assistance.
14