Test Timeout Feature; Dbm Tests - Paradyne iMarc SLV Operation Manual

5. Troubleshooting

Test Timeout Feature

A Test Timeout feature is available to automatically terminate a test (as opposed to
manually terminating a test) after it has been running a specified period of time.
It is recommended that this feature be used when the iMarc unit is remotely
managed through an inband data stream (PVC). If a test is accidently commanded
to execute on the interface providing management access, control is regained
when the specified time period expires, automatically terminating the test.
To use this feature, enable the Test Timeout configuration option, and set a
duration for the test to run in the Test Duration (min) configuration option (see
Configuring General System Options in the

DBM Tests

The Test menu allows you to run PVC loopbacks and test patterns on the unit and
its DBM interface. It is available to users with a security access level of 1 or 2.
Currently, there are no physical tests for a BRI DBM interface.
DBM tests are started and monitored the same as the network tests. See
and Test Status Messages
backup-related test messages appearing on the System and Test Status screen.
See
5-20
NOTE:
These configuration options do not pertain to tests commanded by the DTE,
like a DTE-initiated External Loopback.
in Chapter 3, Status and Statistics, for ISDN
PVC Tests on page 5-23 on for additional information.
May 2003
iMarc SLV Configuration
9000-A2-GB33-20
Reference).
System