Viewing The Trap Event Log; Troubleshooting Tables; Device Problems - Paradyne iMarc SLV Operation Manual

Viewing the Trap Event Log

The Trap Event Log displays all traps stored in the SNMP trap event log. ASCII
trap strings used to describe trap events are provided in the tables contained in
Standards Compliance for SNMP Traps (see the
See
additional information.

Troubleshooting Tables

The unit is designed to provide many years of trouble-free service. However, if a
problem occurs, refer to the appropriate table in the following sections for possible
solutions.

Device Problems

Table 5-2.
9000-A2-GB33-20
Trap Event Log in Chapter 3, Status and Statistics, for a screen example and
Device Problems (1 of 2)
Symptom Possible Cause
No power, or the LEDs The power cord is not
are not lit. securely plugged into the
wall receptacle to rear panel
connection.
The wall receptacle has no
power.
Power-On Self-Test The unit has detected an
fails. Only Alarm LED internal hardware failure.
is on after power-on.
May 2003
5. Troubleshooting
iMarc SLV SNMP Reference).
Solutions
Check that the power cord is
securely attached at both ends.
Check the wall receptacle
power by plugging in some
equipment that is known to be
working.
Check the circuit breaker.
Verify that your site is not on an
energy management program.
Reset the unit and try again.
Contact your service
representative.
Return the unit to the factory
(refer to Warranty, Sales,
Service, and Training
Information on page A of this
document).
5-15