Physical Tests (9623, 9626) - Paradyne iMarc SLV Operation Manual

5. Troubleshooting

Physical Tests (9623, 9626)

An iMarc unit's physical tests screen for the network interface is shown below. For
the user data port, only the DTE Loopback is available.
Physical Tests Screen Example
The ResetMon function key at the bottom of the screen only appears when a
Monitor 511 test pattern is Active. Select ResetMon to reset the monitor pattern
error counter.
5-42
Main Menu→Test→[Network Physical Tests/Data Port Physical Tests]
main/test/network
Device Name: Node A
Test Command
Local Loopbacks
CSU Loopback: Start
DSU Loopback: Start
Pattern Tests
Send 511: Start
Monitor 511: Start
--------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu
ResetMon
CAUTION:
You should not run these tests with frame relay equipment attached;
you must disconnect the frame relay equipment and use external test
equipment.
May 2003
NETWORK 1 PHYSICAL TESTS
Status Results
Inactive 0:00:00
Inactive 0:00:00
Inactive 0:00:00
Active 0:00:00 - Errors 99999+
9626
5/26/2000 23:32
MainMenu Exit
9000-A2-GB33-20